Thanks so much dixiedragon and soapbuddy! I un-molded and cut the soap today. It is not as oily as I first thought. Ya'll are right, I think it will be fine after it cures a while.
I was going for a white swirl in orange. When I poured the soap, it seemed a little thin to me, so I didn't swirl it too much for fear the colors would blend together. As it turns out, the exact opposite happened. There is a layer of white on the bottom of the soap, with only a tiny bit of swirl throughout the bar! Also that little bit of swirl is clear instead of white, and I was surprised that it could be that clear. It looks like M&P. But I'm hoping it will turn white after the soap cures, maybe?
Oh, well! I never know what I'm going to get until I cut the bars!
Thanks again! This forum is so helpful, you guys are the best!
